I was going to build my wet wings with aluminum, so I could build them outside the wing and then test and install. I may still do this, but am concerned about getting them the right size and not interfering with the twist of the wing as they are going in the outboard wing. I am not sure that this is even a factor.
So, I am thinking that I might build glass wings in the wing, but would want to go in from the bottom so I would not have to repair the top of the wing. I am concerned about support for this type of tank built into the wing. I have studied both Marks' sites on the fuel tanks, but will welcome any pros and cons that you may have to offer. I am very apprehensive about assaulting these nice wings that I have now. FYI, they are RAF48 Diehl skins. I am just in the planning stage now, and won't get around to this till winter for sure. I don't want to be down for spring flying. Don't hesitate to respond directly to da...@windstream.net with your comments and suggestions. Daniel R. Heath da...@windstream.net See N64KR at <http://krbuilder.org/> http://KRBuilder.org - Then click on the pics
