Peter Drake wrote: > I am using a similar elevator linkage set up to yours with rods & cables. > Did you use any kind of bushing where the bellcranks pivot on the bolt? > and what lever arm distances for the cable shackles and rod linkages were > on > these bellcranks?
I'm pretty sure I used an oil impregnated bronze bushing there, as in most places I have a bellcrank of any kind. I think the spacing was 2.5", maybe 2.75, maybe 3", I forget, but it's the same in both places. I'll try to remember to measure them next time I'm close to them. The front bellcrank is a little tall so that new holes can be drilled in it to change the ratio between it and the stick, but I haven't felt the need to do that. Mark Langford, Huntsville, Alabama see KR2S project N56ML at http://home.hiwaay.net/~langford email to N56ML "at" hiwaay.net
