Mark Don't heat them you will get a bigger bubble.... I speak from experience. Sand it down and layup a new layer or 2 depending how deep you have to sand....
Lee ----- Original Message ----- From: "Mark Jones" <flyk...@wi.rr.com> To: "KR Net" <kr...@mylist.net> Sent: Sunday, September 25, 2005 7:21 AM Subject: KR> Bubbles > Net Heads, > I have acquired a few bubbles under the fiberglass skin on my stub > wings.Apparently these are some sort of gas bubble which has caused the > phenomenon. The largest one is about 1 1/2 inch wide and 2 inches long. > These bubbles were fairly hard till I drilled a pin size hole in them to > relieve the pressure. Now, I can push the skin down to the foam easily. I > was hoping by drilling the pin holes the skin would eventually lay flat > however this has not happened yet. Now I am thinking heating them with a > heat gun might do the trick. Have any of you experienced this and how did > you rectify the problem? > > Mark Jones (N886MJ) > Wales, WI USA > E-mail me at flyk...@wi.rr.com > Visit my KR-2S CorvAIRCRAFT web site at > http://mywebpage.netscape.com/n886mj > > > > > _______________________________________ > Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp > to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net > please see other KRnet info at http://www.krnet.org/info.html > > >
