You may remember my making several posts, asking for information about the installation of the Electronic Ignition from GPASC. Our real concern was the fear we had in dropping the distributor drive in the hole, and drilling and taping into the case for the set screws.
Well, we got over the fear of dropping the drive, because it turned out to be easy, but the issue of drilling and taping the case and putting a set screw into the O ring on the module, kept nagging at us. We looked for another way and found it. The real proof that it works is in the testing, of course, but I tried as hard as I could to turn this module and could not do, it after it was clamped in place. By flipping the stock clamp over and reversing the bend of the hold down bar and using a socket cap screw instead of a bolt, we were able to do it without drilling and the overall installation turned out to be quite easy. The first three pics show it in pretty good detail. If you have any questions, don't hesitate to ask. http://kr-builder.org/FirewallForward/index.html See N64KR at http://KR-Builder.org - Then click on the pics There is a time for building and a time for FLYING and the time for building has expired. Daniel R. Heath - Columbia, SC See you in Mt. Vernon - 2005 - KR Gathering
