>angle crank at the pre-determined pace. Look at the 7th picture down from
>the top .....straightforward and really works well.....
>
>Oscar ZunigaSan Antonio, TX
> .........................i am in the process of tapering the spars for
> the as5046 section as well . what i have done is by useing a protractor
> cut all the angles needed onto wedges, the intention is to slide the
> wedge under each end of the spar, clamp to a cutting board and slide the
> whole lot through the saw as if cutting a plain taper... this is in its
> untried state at the moment. if any one has tried or sees a problem feel
> free to eductate me .... with thanks..
>
>
>_______________________________________
>to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net
>please see other KRnet info at http://www.krnet.org/info.html
