I used flox and nylon bolts to flox nut plates for my fuel gauge sending unit, before installing it into the tank, and when I tested the procedure, found the flox sticking to the nylon. So I cut the nylon screws to be just long enough to reach "bottom" in the nut plate, and then was able to flox over the whole plate, allow to cure and then back out the screw with just a small amount of pressure to break the tip free. Just some thoughts...
Colin & Bev Rainey KR2(td) N96TA Sanford, FL crain...@cfl.rr.com http://kr-builder.org/Colin/index.html
