Bob Farmer wrote: From: <frlfar...@wmconnect.com> To: <kr...@mylist.net> Sent: Sunday, July 25, 2004 4:31 AM Subject: Re: KR> HAPI Engine Mount
> I have a mount but do not know what accessory case it fits. Engine mount > holes are approx 11 5/8" lower to upper 10 1/2" between the lower and 6 11/16" > between the upper. Anyone know which I have. > I believe I have the same mount which I bought from Hapi. The dimensions check with mine. The only dimension that I could not measure accurately was the 10 1/2 inch between the lower mounts as my alternator and starter are in the way. Just for further identifications: There is a tube between the lower engine mount on the pilot side and the lower firewall mount on the co-pilot side. Upper engine mount each have one tube welded Upper engine mount, both sides have one tube welded. Left bottom engine has three tubes welded on it; Bottom right engine mount has two tubes welded on it. Upper *Firewall* mounts have two tubes each.. Lower *Firewall* mounts - left one tube, right two tubes. And now what you have been waiting for!! It is for a Hapi Engine: 75-DEH Magnum 1915 cc 75hp @ 3400 rpm Dual Electronic Ignition Hydraulic Valve Lifters Alternator 45 Amps. Note: DEH obviously stands for Dual, Electronic, Hydraulic. Hope this helps. Sorry for late reply but vacation came between then and now. Regards, Louis Louis Staalberg Payson, AZ n...@cbiwireless.com
