>rub out the line with a normal pencil rubber. because the pencil line was >drawn 90deg to the grain of the ply so I had to rub up and down with the >grain while slowly following the line covering quite a wide area in the >process.My question is this: What is the effect of this on the epoxy to ply >joint in areas where the rubber has covered, if any? >Dene Collett ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Dene, I don't recall anyone answering your question so I'll throw out my thoughts on the matter. A good cleaning of the area should prevent any problems. The rubber is not something that is going to penatrate the wood as say a glue or liquid would. Also, if you have a concern could you turn the ply over and glue on the opposite side and put the "erased" side on the exterior? Larry Flesner
