Larry, Try bolting a 2x2x1/8 aluminum angle to a 2x4x1/8 sheet with (4) AN3 bolts through the aileron spar. Be sure to use big fender washers so you don't crush the lumber. The bolts at the top nearest the hinge can use the hinge as a washer. Run some epoxy through the lumber holes using a pipe cleaner to seal the lumber against dry rot. Sid Wood, KR-2 N6242 Mechanicsville, MD sidney.w...@titan.com
-----Original Message----- From: krnet-bounces+smwood=titan....@mylist.net [mailto:krnet-bounces+smwood=titan....@mylist.net]On Behalf Of larry severson Sent: Tuesday, February 17, 2004 12:14 PM To: KRnet Subject: KR>4x2x1/8 aluminum extrusion Where can I get the extrusion needed for the aileron hinge? AS does not carry it. Larry Severson Fountain Valley, CA 92708 (714) 968-9852 lar...@socal.rr.com _______________________________________ to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net please see other KRnet info at http://www.krnet.org/info.html
