The bolt size is 1 1/8 x 5" NC. Drill and tap the threaded end of the bolt for 1/2" NC and install a bolt in it. Cut the 1/2" bolt off 2 1/4" long and taper the end the same angle as a drill bit. This will pop it off with no problem. Ralph Snyder Burbank, CA
On Sun, 18 Jan 2004 13:30:20 -0500 Kenneth L Wiltrout <klw1...@juno.com> writes: > > I'm pulling down the 2100 Revmaster to reseal it. Any body know the > bolt > size that acts as the prop hub puller. > Thanks Guys. > > Looking forward to Sun'n Fun 2004!!!!!!!!! > > ________________________________________________________________ > The best thing to hit the internet in years - Juno SpeedBand! > Surf the web up to FIVE TIMES FASTER! > Only $14.95/ month - visit www.juno.com to sign up today! > > _______________________________________ > to UNSUBSCRIBE from KRnet, send a message to krnet-le...@mylist.net > please see other KRnet info at > http://www.krnet.org/instructions.html > >
