I am ready to finish up the oil system layout and rear starter on my corvair and need a couple suggestions. I plan to NOT use tha fuel pump so have decided to do away with the pump housing/flange/filter block. To run a remote filter and cooler should I tie in off of a milled piece on the rear housing or put in fittings ala Mark Langford at the cooler location? Or could a combination of oil leaving out of the new ly milled top plate and returning at the cooler location work? I have my starter and fittings to get started but want to do this right. WW's book helps but there may be many new ideas out there now. Also , where is the best place to run a sender? Thanks Bill
