I drilled through the foam rims in mine with a piece of 1" PVC pipe. I used a hacksaw to cut some hole saw looking teeth on the end of it first. No need to get fancy, just four or six triangles cut on the end do fine. Once you get the pipe through just put the wires or a pull string through and hold the end when you pull out the pipe. You could also use thin wall pipe and leave it in as a wireway if you don't mine the extra weight.
Colin wrote: Netters, I know everyone is gearing up for the Gathering, and I wish I were going but... I am trying to wire my wings for the combination position/strobe/rear nav and the wiring that the previous owner installed broke as I was trying to pull new wiring through the wing. Does anyone know a painless way to run the wiring through the wing without opening it up? I tried using a long rod to feed the wiring, but I think I am damaging the ribs and do not want to continue that route. I have Dan Diehl wing skins if that makes a difference. I have already made the cutout in the tip and am ready to install, if I can just feed the necessary wiring to it. Colin Rainey KR2(td) crain...@cfl.rr.com Sanford, Florida FLY SAFE!!!!_______________________________________________ see KRnet list details at http://www.krnet.org/instructions.html
