Dan Heath wrote: "Does anyone out there in NET land, know how to make an aileron straight"
Dan I've had good results taking two lengths of aluminum angle and covering them with duct tape. Then clamp them on the training edge with the perpendicular leg at the training edge and the parallel leg along the surface. You have to be careful with the clamps to make sure you don't over-tighten them and cause any waves in the training edge. If you set it up straight it will hold the trailing edge in alignment as it cures. Regards, Bob Lee ______________________________ N52BL KR2 Suwanee, GA 30024 91% done only 51% to go! Phone/Fax: 770/844-7501 mailto:b...@flyboybob.com http://flyboybob.com
