Dan, Mine has holes at every bulkhead, one on each side of the bottom on the front side of the crossmembers. However, I only used a 1\16" drill bit. They need to be bigger because they stopped up when it had water in it. Best regards, Rick Wilson. rwdw2...@yahoo.com --- Dan Heath <da...@alltel.net> wrote: > Harold, > > I am sure that you are correct about drilling those > drain holes. However, > while I don't go around looking at the bottom of > KRs, I'll bet there aren't > many around with that many holes in the bottom. > > I am going to put drain holes in the bottom of the > WannaBee, but probably > not at every crossmember. I am also going to put in > an inspection plate > under the Horiz stab, so I can see behind that > bulkhead. I sure wish I had > put in the drain holes before I closed it up, > because I want to put in > screens to keep the bugs out. > > N64KR > > Daniel R. Heath - Columbia, SC > > da...@kr-builder.org > > See you in Red Oak - 2003 > > See our KR at http://KR-Builder.org - Click on the > pic > See our EAA Chapter 242 at http://EAA242.org > _______________________________________________ > see KRnet list details at http://www.krnet.org/instructions.html
__________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com
