Bob Lee e-mailed me a question that I will reply to the net as others may have the same question.
>Did your spinner have a front plate? If so, how did you locate and install >the front plate? >Bob Lee >______________________________ Yes it did. When I ordered the spinner I had to give them the thickness of the prop and they made the front plate to fit at that location. I installed the front plate between the crush plate and the propeller so that all the spacing was correct. When installed , the spinner rear edge fit just to the rear edge (within 1/16") of the rear edge of the rear mount plate and snug against the front plate. Because of the design of the front plate, I had to notch it out for the propeller. Some designs make that unnecessary. Your results may vary! Larry Flesner
