Approx,. 9 3/4 to 10 inches vertically from bottom of engine pan to bottom of collector joint. Hard to measure without removing the lower cowling at this time. Chris
Sent from my iPad > On Jan 22, 2017, at 8:38 AM, Mark Langford via KRnet <krnet@list.krnet.org> > wrote: > > Chris Gardiner wrote: > >> The only difficulty I had with the Revmaster is that it is slightly >> different at the back and interfered with my intake manifold ( Zenith >> 1821 carb.) > > Is your intake a Great Plains that angles back toward the center for a few > inches on top and then goes straight down on each side, then a 90 turn in to > meet in the middle? If so, that's what I also have. YES! > > A measurement from the bottom of the engine to the lower end of the exhaust > collector joint See above > > Mark Langford > m...@n56ml.com > http://www.n56ml.com > > > _______________________________________________ > Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. > Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change > options > To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org _______________________________________________ Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
