Thanks Roger. I wondered about that, seems like it would take at least a full turn or more to bottom the needle.
Chris On 11/2/2015 6:07 AM, Roger via KRnet wrote: > Chris > > The Tillotson does not have a idle cutoff per say, but all fuel going > to both the idle and main circuit has to go through the main needle. > If you turn the main mixture to the stop the engine will quit even at > idle. > > I always shut down using the ignition switch and leave the mixture at > the setting it was when I landed, just a tad rich. It has never > dribbled fuel while sitting even when I forget to turn off the fuel > valve. > > Roger Bulla > > -----Original Message----- From: Chris Kinnaman via KRnet > Sent: Sunday, November 1, 2015 7:29 AM > To: KRnet > Cc: Chris Kinnaman > Subject: KR> Question for Roger Bulla > > Roger, > Do you use the mixture control on your Tillotson carb for an idle cutoff? > Thanks > Chris > > _______________________________________________ > Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. > To UNsubscribe from KRnet, send a message to KRnet-leave at list.krnet.org > please see other KRnet info at http://www.krnet.org/info.html > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to > change options > > _______________________________________________ > Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. > To UNsubscribe from KRnet, send a message to KRnet-leave at list.krnet.org > please see other KRnet info at http://www.krnet.org/info.html > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to > change options > >
