I have been doing a little glass work on my canopy ( see pics). The outside temp was in the low 30s...around 40 in the garage. I have an oil filled electric radiator that will bring the temp in the garage to close to 50. I use US composite medium pot life resin...usually cures in about 8 hours. The other night I did the radiator trick for about 10 hours...then before I went to bed I used a heat gun to raise the temp to 150 and held it there for a few minutes...then shut everything off. Even though the temp was freezing overnight it was cured by morning. The heat gun works OK for small areas but I wouldn't recommend it for large areas.
https://sites.google.com/site/mykr2stretch/ https://sites.google.com/site/mykr2stretch/parts-for-sale On Jan 3, 2015 1:40 AM, "Dubi Gefen via KRnet" <krnet at list.krnet.org> wrote: > Hello Friend > > > > I am preparing my aircraft to painting so now I am glassing the surface > area > of the wings and also the fuselage. > > My problem is the temperature of environment. > > The temperature in Israel drop down less than 53F and the glass is not > getting hard. > > > > Could you suggest other type of epoxy? > > Now I am using PR2032 Aeropoxy > > > > Best regards Dubi Gefen > > <mailto:Dubi_g at maanit.org.il> Dubi_g at maanit.org.il > > <http://www.dubigefen.50megs.com/> http://www.dubigefen.50megs.com/ > > +972-54-4921263 > > > > > This mail was sent via Mail-SeCure System. > > > _______________________________________________ > Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. > To UNsubscribe from KRnet, send a message to KRnet-leave at list.krnet.org > please see other KRnet info at http://www.krnet.org/info.html > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change > options >
