Well done! It is always good advice when backed by research. Thanks. -----Original Message----- From: Oscar Zuniga Sent: Saturday, November 02, 2013 1:47 PM To: krnet at list.krnet.org Subject: KR> Post curing wings
Good information about post-curing. Check the heat distortion temperature for the foam board that you're using if you decide to post-cure. Some of the molded polystyrene boards (such as pink Owens-Corning Foamular; blue Dow Styrofoam) have heat distortion temperatures in the 100-105C range (210-220F), but others may be lower. If the foam substrate gets into those temperatures, you could find that the piece that you're post-curing may take on some permanent distortion. This topic has come up over the years when discussing the use of less reflective, generally darker paint colors on composite airplanes with a foam substrate... like the KR. A darker airplane parked out in the sun can develop temperatures in the foam that can exceed the distortion temperature, which is one of the reasons that KRs have traditionally had white or light colored paint jobs. Not saying that it will melt like Icarus' wings, but it could result in a droop, twist, or other distortion. The urethane foams (such as Last-A-Foam) have much higher distortion temperatures than polystyrene board. Oscar Zuniga Medford, OR _______________________________________________ Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search. To UNsubscribe from KRnet, send a message to KRnet-leave at list.krnet.org please see other KRnet info at http://www.krnet.org/info.html see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options