My KR Christmas Wish.
I asked "Santa" for a new rpm guage, a 6 inch linear actuator with switch, and
a bus and battery to run both of those.
The linear actuator was very easy to retrofit. I used the same suport brace as
the mechanical belly board actuation system. Wiring is connected to my new
electrical bus that I installed on the passenger side wall under the dash
board. The belly board extends and retracts in about 20 Seconds, much faster
than I had expected. I don't get as much travel, I was getting 85 degrees with
the mechanical system and only about 70 degrees with electrical, it will
probably still work.
The battery is the portable kind that you would use to jump start your car. It
is lght, portable, digital readout of remaining charge percentage, built in
flashlight. I have no starter or alternator so I will pull it out to charge on
the bench.
Joe Nunley CW2 US Army RetiredBaker JROTC Instructor Baker Florida
_______________________________________________
Search the KRnet Archives at http://tugantek.com/archmailv2-kr/search.
Please see LIST RULES and KRnet info at http://www.krnet.org/info.html.
see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change
options
To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
