Hi Steve, It’s more likely a difference in selection than tab vs. G. Eeschema now supports stingy and hungry selections. If you drag from the left to the right then only fully-selected objects will be included (this is the 5.1 behaviour). However, if you drag from the right to the left then even partially-selected objects will be included. So if you made the selection in “selecting.png” from right-to-left then you also selected the two horizontal wires and the G command then dragged them as well.
It should get what you expect if you either drag from left-to-right or drag to just include the resistor and part of each vertical wire. Cheers, Jeff. > On 17 Jun 2019, at 18:56, Steven A. Falco <[email protected]> wrote: > > I've been trying out eeschema 6.0, and I see a strange rubber-banding > behavior change. > > I put four screen-shots here: > > https://www.dropbox.com/sh/pz9rfzrlxfdpb8a/AAC-B5yBKUtjzhyyWqKbXdSya?dl=0 > > In "before.png" I show three resistors connected together, and in > "selecting.png" I show how I select just the right-most resistor and its two > attached wires. > > In 5.1.2, I then hit "Tab" and drag the resistor. I get the result shown in > "hit_tab_in_5.1.png". The resistor is moved, and the wires up to the next > component (i.e. the middle resistor) are rubber-banded. > > However, in 6.0, there is no "Tab" hotkey, so instead I type "g", which I had > hoped would work like 5.1's Tab hotkey. I get the result shown in > "hit_g_in_6.0.png". The resistor is moved as expected, but all the wires are > rubber-banded, including the ones connected to the left-most and center > resistors. That seems like the wrong behavior. I don't know if this is > intentional or a bug. > > Steve > > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
