There definitely was a change in the commit that removed
InvokeNonCopperZonesEditor() from the ZONE_CREATE_HELPER tool so I can
see how this would be jarring for users that have been using that
feature. I'm going to wait until Orson responds to my original
question. If we are going to make a behavior change like this, I would
like to understand why. I see in the commit message that it states
"Previously zone drawing tool was used to draw copper and graphical
polygons, but now there is a dedicated tool for that." Does the polygon
tool allow you to edit zones on non-copper layers or were zones on
non-copper layers saved as polygons? If the latter is the case then I'm
guessing this change is not significant but if that is not the case then
there could be some editing issues.
Wayen
On 02/23/2018 07:55 PM, Andrzej Wolski wrote:
But setting the width of a graphical polygon to 0 removes the size
issue Andrzej mentioned.
But the you don't have them with rounded corners :)
For filling vs. non-filling, I don't personally see the usefulness in
having the fill algorithm run over a polygon that will always be
filled. But maybe there's a use-case I'm missing?
I didn't mean filling, but displaying in outline mode (hatched, fully
hatched...)
Andrzej
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : [email protected]
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp
