Seth, I just tested this. The disambiguation menu is shown but it still drags both lines and it breaks the undo as well. Maybe the undo part is fixed by your other patch set.
Cheers, Wayne On 11/27/2017 5:51 PM, Seth Hillbrand wrote: > In Eeschema, if you draw two lines on top of each other that are not > the same type, e.g. wire and bus; or bus and graphic line, and then > hover over the lines and use the 'drag' hotkey, both lines will drag at > the same time. The correct behavior should show disambiguation. > > The attached patch corrects this behavior by distinguishing the line > types in SCH_COLLECTOR::IsCorner(). > > Reference: https://bugs.launchpad.net/kicad/+bug/1635984 > > -Seth > > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
