Le 17/11/2017 à 13:42, Nick Østergaard a écrit : > Isn't this the expected behavior? > > Usually you can sort of trim a wire by drawing from the end of it and into > itself to remove that > section. >
No: this is a merge algo, used to cleanup wires, and must merge collinear segments, not remove connections. the merging algo does not merge correctly these 2 collinear segments. It *removes* an existing connection. " draw a horizontal wire from point A to Point B. Then draw a second wire from the middle of AB to B the expected result is only one wire from A to B but the result is one shorter wire from A to the middle of AB." However if the second wire is created from the middle of AB to A, the merge is OK. > 2017-11-17 11:03 GMT+01:00 jp charras <jp.char...@wanadoo.fr > <mailto:jp.char...@wanadoo.fr>>: > > Le 10/10/2017 à 07:19, Seth Hillbrand a écrit : > > Sorry for the repeat on this one. I missed a corner case in testing > the first time (overlapping, > > horizontal segments offset in Y) > > > > I've attached a collapsed patch for this. > > > > -Seth > > > > Hi Seth, > > I tested you patch and unfortunately it did not very well. > > For instance a basic case: > > draw a horizontal wire from point A to Point B. > > Then draw a second wire from the middle of AB to B. > the expected result is only on wire from A to B > but the result is one shorter wire from A to the middle of AB. > > > -- > Jean-Pierre CHARRAS > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > <https://launchpad.net/%7Ekicad-developers> > Post to : kicad-developers@lists.launchpad.net > <mailto:kicad-developers@lists.launchpad.net> > Unsubscribe : https://launchpad.net/~kicad-developers > <https://launchpad.net/%7Ekicad-developers> > More help : https://help.launchpad.net/ListHelp > <https://help.launchpad.net/ListHelp> > > -- Jean-Pierre CHARRAS _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
