On 4/14/2014 3:14 PM, Dick Hollenbeck wrote: > On 04/14/2014 02:03 PM, Wayne Stambaugh wrote: >> On 4/14/2014 2:37 PM, Dick Hollenbeck wrote: >>> On 04/14/2014 01:20 PM, Wayne Stambaugh wrote: >>>> I was working on a project with a project specific footprint library >>>> table when I noticed that it appeared to have all of the default legacy >>>> footprint libraries instead of the libraries that I had defined. I went >>>> and looked at the project fp-lib-table and sure enough it only had the >>>> two custom libraries that I originally added to it. Upon further >>>> inspection I noticed that KIPRJMOD is incorrectly pointing to system >>>> template path instead of the project path (see attached image). Is >>>> anyone else seeing this? This used to work just fine. Did someone >>>> change the CWD code recently? >>>> >>>> Wayne >>> >>> >>> Your graphic is not showing the project specific tab. So I think I have no >>> starting point >>> in understanding your bug report. >>> >> >> Here is the fp-lib-table editor image with the project tab selected. >> The problem is that KIPRJMOD is defined as the template path (I selected >> it to highlight it) even though the netlist file that is open is in the >> project folder that contains a valid fp-lib-table file. I looked at the >> fp-lib-table in the template folder and sure enough that is the >> fp-lib-table that is being loaded instead of the project fp-lib-table >> file. There are only two entries in the project fp-lib-table. > > > I'd put breakpoint at > > > 1) line 58 of common/project.cpp > 2) line 94 of common/project.cpp > > > Check the call stack when you hit either of those. > Check the full name of the project at either place. > > At line 94 the flow should go to the else. >
I uncommented the wxLogDebug call in PROJECT::SetProjectFullName() and here is the debugging output after opening a project netlist with CvPcb: [900] Setting env KIPRJMOD to 'C:\Users\Wayne\Documents\Motion Sensors\pca174'. [900] Setting env KIPRJMOD to 'E:\MinGW\msys\1.0\home\Wayne\share\template'. SetProjectFullName() is getting called a second time with the template path which is overwriting the correct project path. If I get some time tomorrow, I'll see if I can find the time to dump the call stack to find the where second offending call is coming from. _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
