Hello,
I have decided to investigate reorganizing how I terminate customer
broadband sessions and I have some questions about differences in Cisco
vs Juniper radius profiles:
Currently in radius, I have a number of attributes I push out upon
authentication which can include things like Framed-IP-Address,
Framed-IP-Netmask, Framed-Route and Filter-id. I know these are pretty
standard and likely are supported out of the box on Cisco and likely
juniper too. However, I also do rate limiting in radius since my BNGs
are cisco, and these rely on the 'Cisco-Service-Info' attribute with
values like "QU;30000000;5625000;11250000;D;30000000;5625000;11250000",
which establishes a 30m/30m pipe. I like using radius for this but most
of what I have seen says I need instead to establish profiles on the
Junos box itself in advance and reference them by name. This seems
really inconvenient. I have done some poking around and see there is
some dynamic profile support, but I am just not connecting the dots how
I would get a similar feature to allow me to set the shaping rates in
radius for juniper. If it matters, my primary access method is PPPoE but
in the future I will move to a DHCP / CGNAT arrangement but still want
to have the filtering/shaping functionality.
Thank you.
Mike-
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
