--- Begin Message ---
On 14-Nov-19 14:19, [email protected] wrote:
There are several places where you can run your keepalieve
a) RPD
b) RE PPMd
c) LC CPU PPMd
d) NPU (dispatch block in the LU/XL)
And it depends on config where you run it.
... and on hardware and on defaults of the Junos version you run.
Then PPMD can run on RE obviously or can be distributed onto LC -now this is
where my confusion comes in.
That's because I was under the impression that it's the LC CPU hosting the
PPMD in distributed mode,
packet generation by lookup chip used be referred as 'inline'
by LC CPU - distributed.
check first reply here:
https://forums.juniper.net/t5/Junos/Inline-BFD-vs-distributed-BFD/td-p/463242
Also is there a cmd I can use to switch between LC CPU and LU?
I recall there is a hidden knob (mentioned in MX series book):
https://books.google.nl/books?id=SVvnDAAAQBAJ&pg=PA12&lpg=PA12&dq=junos+inline+bfd&source=bl&ots=Dt7vVwAShk&sig=ACfU3U0FWXmAHyJA7urRdPO5w5kJZFdwjw&hl=en&sa=X&ved=2ahUKEwj38tz5rfblAhVRoZ4KHbCjDqEQ6AEwDXoECAkQAQ
--- End Message ---
_______________________________________________
juniper-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/juniper-nsp
