- **status**: open --> pending
- **Comment**:
Should be fixed. Waiting for feedback from a known user.
---
** [bugs:#516] RemodelerTool not correct**
**Status:** pending
**Milestone:** OJ_1.16
**Created:** Wed Nov 25, 2020 11:29 AM UTC by michael michaud
**Last Updated:** Wed Nov 25, 2020 11:29 AM UTC
**Owner:** michael michaud
There are several bugs in ModelerTool :
Z should not be interpolated point before or point after has no z
Z interpolation is not correctly computed in the normal case
When the new geometry produced is invalid, there is a warning, but the
transaction is not rolled back
Corrections are in progress
---
Sent from sourceforge.net because jump-pilot-devel@lists.sourceforge.net is
subscribed to https://sourceforge.net/p/jump-pilot/bugs/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/jump-pilot/admin/bugs/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
Jump-pilot-devel mailing list
Jump-pilot-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/jump-pilot-devel
