Uncheck the JDE->Project->Auto Switch menu item. Alternatively, you can
manually add the following line to your prj.el file.
'(jde-project-context-switching-enabled-p nil)
Hope this helps.
--
Chris Britton
[EMAIL PROTECTED]
-----Original Message-----
From: Karr, David [mailto:[EMAIL PROTECTED]
Sent: Friday, December 17, 2004 10:48 AM
To: [EMAIL PROTECTED]
Subject: Would be nice if "prj.el" didn't load until needed
One minor annoyance I find with JDEE is when I'm viewing two files, from two
different projects. I'm writing code in one file, but I switch to the other
buffer to check how something was done, and then I go back to the other
buffer. Each time I switch to each buffer, the "prj.el" for that project
loads (which I just use to set the global classpath). Each of these takes a
couple of seconds to finish. I wish there was a way to optimize this, so
that the "prj.el" only loads when it's necessary (or some compromise in that
direction).
