Starting from Meteor Lake, the Kumeran interface between the integrated
MAC and the I219 PHY works at a different frequency. This causes sporadic
MDI errors when accessing the PHY, and in rare circumstances could lead
to packet corruption.
To overcome this, introduce minor changes to the Kumeran idle
state (K1) parameters during device initialization. Hardware reset
reverts this configuration, therefore it needs to be applied in a few
places.
Fixes: cc23f4f0b6b9 ("e1000e: Add support for Meteor Lake")
Signed-off-by: Vitaly Lifshits <vitaly.lifsh...@intel.com>
---
v3: refactor code to avoid edge case errors
v2: address community comments
v1: initial version
---
drivers/net/ethernet/intel/e1000e/defines.h | 3 +
drivers/net/ethernet/intel/e1000e/ich8lan.c | 80 +++++++++++++++++++--
drivers/net/ethernet/intel/e1000e/ich8lan.h | 4 ++
3 files changed, 82 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/intel/e1000e/defines.h
b/drivers/net/ethernet/intel/e1000e/defines.h
index 5e2cfa73f889..8294a7c4f122 100644
--- a/drivers/net/ethernet/intel/e1000e/defines.h
+++ b/drivers/net/ethernet/intel/e1000e/defines.h
@@ -803,4 +803,7 @@
/* SerDes Control */
#define E1000_GEN_POLL_TIMEOUT 640
+#define E1000_FEXTNVM12_PHYPD_CTRL_MASK 0x00C00000
+#define E1000_FEXTNVM12_PHYPD_CTRL_P1 0x00800000
+
#endif /* _E1000_DEFINES_H_ */
diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.c
b/drivers/net/ethernet/intel/e1000e/ich8lan.c
index 2f9655cf5dd9..5a02d810c69f 100644
--- a/drivers/net/ethernet/intel/e1000e/ich8lan.c
+++ b/drivers/net/ethernet/intel/e1000e/ich8lan.c
@@ -285,6 +285,45 @@ static void e1000_toggle_lanphypc_pch_lpt(struct e1000_hw
*hw)
}
}
+/**
+ * e1000_reconfigure_k1_exit_timeout - reconfigure K1 exit timeout to
+ * align to MTP and later platform requirements.
+ * @hw: pointer to the HW structure
+ *
+ * Context: PHY semaphore must be held by caller.
+ * Return: 0 on success, negative on failure
+ */
+static s32 e1000_reconfigure_k1_exit_timeout(struct e1000_hw *hw)
+{
+ u16 phy_timeout;
+ u32 fextnvm12;
+ s32 ret_val;
+
+ if (hw->mac.type < e1000_pch_mtp)
+ return 0;
+
+ /* Change Kumeran K1 power down state from P0s to P1 */
+ fextnvm12 = er32(FEXTNVM12);
+ fextnvm12 &= E1000_FEXTNVM12_PHYPD_CTRL_MASK;
+ fextnvm12 |= E1000_FEXTNVM12_PHYPD_CTRL_P1;
+ ew32(FEXTNVM12, fextnvm12);
+
+ /* Wait for the interface the settle */
+ usleep_range(1000, 1100);
+
+ /* Change K1 exit timeout */
+ ret_val = e1e_rphy_locked(hw, I217_PHY_TIMEOUTS_REG,
+ &phy_timeout);
+ if (ret_val)
+ return ret_val;
+
+ phy_timeout &= ~I217_PHY_TIMEOUTS_K1_EXIT_TO_MASK;
+ phy_timeout |= 0xF00;
+
+ return e1e_wphy_locked(hw, I217_PHY_TIMEOUTS_REG,
+ phy_timeout);
+}
+
/**
* e1000_init_phy_workarounds_pchlan - PHY initialization workarounds
* @hw: pointer to the HW structure
@@ -327,15 +366,22 @@ static s32 e1000_init_phy_workarounds_pchlan(struct
e1000_hw *hw)
* LANPHYPC Value bit to force the interconnect to PCIe mode.
*/
switch (hw->mac.type) {
+ case e1000_pch_mtp:
+ case e1000_pch_lnp:
+ case e1000_pch_ptp:
+ case e1000_pch_nvp:
+ /* At this point the PHY might be inaccessible so don't
+ * propagate the failure
+ */
+ if (e1000_reconfigure_k1_exit_timeout(hw))
+ e_dbg("Failed to reconfigure K1 exit timeout\n");
+
+ fallthrough;
case e1000_pch_lpt:
case e1000_pch_spt:
case e1000_pch_cnp:
case e1000_pch_tgp:
case e1000_pch_adp:
- case e1000_pch_mtp:
- case e1000_pch_lnp:
- case e1000_pch_ptp:
- case e1000_pch_nvp:
if (e1000_phy_is_accessible_pchlan(hw))
break;
@@ -419,8 +465,20 @@ static s32 e1000_init_phy_workarounds_pchlan(struct
e1000_hw *hw)
* the PHY is in.
*/
ret_val = hw->phy.ops.check_reset_block(hw);
- if (ret_val)
+ if (ret_val) {
e_err("ME blocked access to PHY after reset\n");
+ goto out;
+ }
+
+ if (hw->mac.type >= e1000_pch_mtp) {
+ ret_val = hw->phy.ops.acquire(hw);
+ if (ret_val) {
+ e_err("Failed to reconfigure K1 exit
timeout\n");
+ goto out;
+ }
+ ret_val = e1000_reconfigure_k1_exit_timeout(hw);
+ hw->phy.ops.release(hw);
+ }
}
out:
@@ -4888,6 +4946,18 @@ static s32 e1000_init_hw_ich8lan(struct e1000_hw *hw)
u16 i;
e1000_initialize_hw_bits_ich8lan(hw);
+ if (hw->mac.type >= e1000_pch_mtp) {
+ ret_val = hw->phy.ops.acquire(hw);
+ if (ret_val)
+ return ret_val;
+
+ ret_val = e1000_reconfigure_k1_exit_timeout(hw);
+ hw->phy.ops.release(hw);
+ if (ret_val) {
+ e_dbg("Error failed to reconfigure K1 exit timeout\n");
+ return ret_val;
+ }
+ }
/* Initialize identification LED */
ret_val = mac->ops.id_led_init(hw);
diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.h
b/drivers/net/ethernet/intel/e1000e/ich8lan.h
index 2504b11c3169..5feb589a9b5f 100644
--- a/drivers/net/ethernet/intel/e1000e/ich8lan.h
+++ b/drivers/net/ethernet/intel/e1000e/ich8lan.h
@@ -219,6 +219,10 @@
#define I217_PLL_CLOCK_GATE_REG PHY_REG(772, 28)
#define I217_PLL_CLOCK_GATE_MASK 0x07FF
+/* PHY Timeouts */
+#define I217_PHY_TIMEOUTS_REG PHY_REG(770, 21)
+#define I217_PHY_TIMEOUTS_K1_EXIT_TO_MASK 0x0FC0
+
#define SW_FLAG_TIMEOUT 1000 /* SW Semaphore flag timeout in
ms */
/* Inband Control */
--
2.34.1
