On to, 2015-05-07 at 12:00 +0530, Vandana Kannan wrote:
> BUN 1: prop_coeff, int_coeff, tdctargetcnt programming updated and tied to
> VCO frequencies. Program i_lockthresh in PORT_PLL_9.
>
> VCO calculated based on the formula:
> Desired Output = Port bit rate in MHz (DisplayPort HBR2 is 5400 MHz)
> Fast Clock = Desired Output / 2
> VCO = Fast Clock * P1 * P2
>
> Prop_coeff, int_coeff, and tdctargetcnt modified according to above
> calculation.
>
> BUN 2: Port PLLs require additional programming at certain frequencies -
> DCO amplitude in PORT_PLL_10
>
> Review comments from Siva which were addressed in the initial version of the
> patch.
> - Change PORT_PLL_LOCK_THRESHOLD to PORT_PLL_LOCK_THRESHOLD_MASK
> - Calculate for HDMI
> - Correct values for vco = 5.4
> - return in case of invalid vco range
>
> v2: Imre's review comments addressed
> - change dcoampovr_en to dcoampovr_en_h
> - change PORT_PLL_DCO_AMP_OVR_EN to PORT_PLL_DCO_AMP_OVR_EN_H
> - Correct lane stagger value for 324MHz
> - Make coef common for HDMI and DP
> - remove superfluous comments
>
> Signed-off-by: Vandana Kannan <vandana.kan...@intel.com>
> Reviewed-by: Sivakumar Thulasimani <sivakumar.thulasim...@intel.com>
> Cc: Sivakumar Thulasimani <sivakumar.thulasim...@intel.com>
> ---
> drivers/gpu/drm/i915/i915_drv.h | 2 +-
> drivers/gpu/drm/i915/i915_reg.h | 6 ++++
> drivers/gpu/drm/i915/intel_ddi.c | 69
> ++++++++++++++++++++++++++++++----------
> 3 files changed, 60 insertions(+), 17 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
> index 136d42a..05a4e1c 100644
> --- a/drivers/gpu/drm/i915/i915_drv.h
> +++ b/drivers/gpu/drm/i915/i915_drv.h
> @@ -304,7 +304,7 @@ struct intel_dpll_hw_state {
> uint32_t cfgcr1, cfgcr2;
>
> /* bxt */
> - uint32_t ebb0, pll0, pll1, pll2, pll3, pll6, pll8, pcsdw12;
> + uint32_t ebb0, pll0, pll1, pll2, pll3, pll6, pll8, pll10, pcsdw12;
> };
>
> struct intel_shared_dpll_config {
> diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
> index 1b31238..b086d26 100644
> --- a/drivers/gpu/drm/i915/i915_reg.h
> +++ b/drivers/gpu/drm/i915/i915_reg.h
> @@ -1185,6 +1185,12 @@ enum skl_disp_power_wells {
> #define PORT_PLL_GAIN_CTL(x) ((x) << 16)
> /* PORT_PLL_8_A */
> #define PORT_PLL_TARGET_CNT_MASK 0x3FF
> +/* PORT_PLL_9_A */
> +#define PORT_PLL_LOCK_THRESHOLD_MASK 0xe
> +/* PORT_PLL_10_A */
> +#define PORT_PLL_DCO_AMP_OVR_EN_H (1<<27)
> +#define PORT_PLL_DCO_AMP_MASK 0x3c00
> +#define PORT_PLL_DCO_AMP(x) (x<<10)
> #define _PORT_PLL_BASE(port) _PORT3(port, _PORT_PLL_0_A, \
> _PORT_PLL_0_B, \
> _PORT_PLL_0_C)
> diff --git a/drivers/gpu/drm/i915/intel_ddi.c
> b/drivers/gpu/drm/i915/intel_ddi.c
> index 9c1e74a..49b9fd8 100644
> --- a/drivers/gpu/drm/i915/intel_ddi.c
> +++ b/drivers/gpu/drm/i915/intel_ddi.c
> @@ -1337,18 +1337,20 @@ struct bxt_clk_div {
> uint32_t int_coef;
> uint32_t gain_ctl;
> uint32_t targ_cnt;
> + uint32_t dcoampovr_en_h;
> + uint32_t dco_amp;
> uint32_t lanestagger;
> };
>
> /* pre-calculated values for DP linkrates */
> static struct bxt_clk_div bxt_dp_clk_val[7] = {
> - /* 162 */ {4, 2, 32, 1677722, 1, 1, 5, 11, 2, 9, 0xd},
> - /* 270 */ {4, 1, 27, 0, 0, 1, 3, 8, 1, 9, 0xd},
> - /* 540 */ {2, 1, 27, 0, 0, 1, 3, 8, 1, 9, 0x18},
> - /* 216 */ {3, 2, 32, 1677722, 1, 1, 5, 11, 2, 9, 0xd},
> - /* 243 */ {4, 1, 24, 1258291, 1, 1, 5, 11, 2, 9, 0xd},
> - /* 324 */ {4, 1, 32, 1677722, 1, 1, 5, 11, 2, 9, 0xd},
> - /* 432 */ {3, 1, 32, 1677722, 1, 1, 5, 11, 2, 9, 0x18}
> + /* 162 */ {4, 2, 32, 1677722, 1, 1, 4, 9, 3, 8, 0, 15, 0xd},
> + /* 270 */ {4, 1, 27, 0, 0, 1, 3, 8, 1, 9, 0, 15, 0xd},
> + /* 540 */ {2, 1, 27, 0, 0, 1, 3, 8, 1, 9, 0, 15, 0x18},
> + /* 216 */ {3, 2, 32, 1677722, 1, 1, 4, 9, 3, 8, 0, 15, 0xd},
> + /* 243 */ {4, 1, 24, 1258291, 1, 1, 5, 11, 3, 9, 1, 15, 0xd},
> + /* 324 */ {4, 1, 32, 1677722, 1, 1, 4, 9, 3, 8, 0, 15, 0x18},
> + /* 432 */ {3, 1, 32, 1677722, 1, 1, 4, 9, 3, 8, 0, 15, 0x18}
We calculate all of prop_coef, int_coef, gain_ctl, targ_cnt,
dcoapovr_en_h, dco_amp, so no need to have fixed values for these. The
corresponding fields should be removed from bxt_clk_div and replaced
with local vars in bxt_ddi_pll_select.
> };
>
> static bool
> @@ -1359,6 +1361,7 @@ bxt_ddi_pll_select(struct intel_crtc *intel_crtc,
> {
> struct intel_shared_dpll *pll;
> struct bxt_clk_div clk_div = {0};
> + int vco = 0;
>
> if (intel_encoder->type == INTEL_OUTPUT_HDMI) {
> intel_clock_t best_clock;
> @@ -1382,11 +1385,7 @@ bxt_ddi_pll_select(struct intel_crtc *intel_crtc,
> clk_div.m2_frac = best_clock.m2 & ((1 << 22) - 1);
> clk_div.m2_frac_en = clk_div.m2_frac != 0;
>
> - /* FIXME: set coef, gain, targcnt based on freq band */
> - clk_div.prop_coef = 5;
> - clk_div.int_coef = 11;
> - clk_div.gain_ctl = 2;
> - clk_div.targ_cnt = 9;
> + vco = best_clock.vco;
> if (clock > 270000)
> clk_div.lanestagger = 0x18;
> else if (clock > 135000)
> @@ -1416,6 +1415,32 @@ bxt_ddi_pll_select(struct intel_crtc *intel_crtc,
> clk_div = bxt_dp_clk_val[0];
> DRM_ERROR("Unknown link rate\n");
> }
> + vco = clock * 10 / 2 * clk_div.p1 * clk_div.p2;
> + }
> +
> + clk_div.dco_amp = 15;
> + clk_div.dcoampovr_en_h = 0;
> + if (vco >= 6200000 && vco <= 6480000) {
> + clk_div.prop_coef = 4;
> + clk_div.int_coef = 9;
> + clk_div.gain_ctl = 3;
> + clk_div.targ_cnt = 8;
> + } else if ((vco > 5400000 && vco < 6200000) ||
> + (vco >= 4800000 && vco < 5400000)) {
> + clk_div.prop_coef = 5;
> + clk_div.int_coef = 11;
> + clk_div.gain_ctl = 3;
> + clk_div.targ_cnt = 9;
> + if (vco >= 4800000 && vco < 5400000)
> + clk_div.dcoampovr_en_h = 1;
> + } else if (vco == 5400000) {
> + clk_div.prop_coef = 3;
> + clk_div.int_coef = 8;
> + clk_div.gain_ctl = 1;
> + clk_div.targ_cnt = 9;
> + } else {
> + DRM_ERROR("Invalid VCO\n");
> + return false;
> }
>
> crtc_state->dpll_hw_state.ebb0 =
> @@ -1435,6 +1460,11 @@ bxt_ddi_pll_select(struct intel_crtc *intel_crtc,
>
> crtc_state->dpll_hw_state.pll8 = clk_div.targ_cnt;
>
> + if (clk_div.dcoampovr_en_h)
> + crtc_state->dpll_hw_state.pll10 = PORT_PLL_DCO_AMP_OVR_EN_H;
> +
> + crtc_state->dpll_hw_state.pll10 |= PORT_PLL_DCO_AMP(clk_div.dco_amp);
> +
> crtc_state->dpll_hw_state.pcsdw12 =
> LANESTAGGER_STRAP_OVRD | clk_div.lanestagger;
>
> @@ -2366,10 +2396,16 @@ static void bxt_ddi_pll_enable(struct
> drm_i915_private *dev_priv,
> temp |= pll->config.hw_state.pll8;
> I915_WRITE(BXT_PORT_PLL(port, 8), temp);
>
> - /*
> - * FIXME: program PORT_PLL_9/i_lockthresh according to the latest
> - * specification update.
> - */
> + temp = I915_READ(BXT_PORT_PLL(port, 9));
> + temp &= ~PORT_PLL_LOCK_THRESHOLD_MASK;
> + temp |= (5 << 1);
> + I915_WRITE(BXT_PORT_PLL(port, 9), temp);
> +
> + temp = I915_READ(BXT_PORT_PLL(port, 10));
> + temp &= ~PORT_PLL_DCO_AMP_OVR_EN_H;
> + temp &= ~PORT_PLL_DCO_AMP_MASK;
> + temp |= pll->config.hw_state.pll10;
> + I915_WRITE(BXT_PORT_PLL(port, 10), temp);
>
> /* Recalibrate with new settings */
> temp = I915_READ(BXT_PORT_PLL_EBB_4(port));
> @@ -2433,6 +2469,7 @@ static bool bxt_ddi_pll_get_hw_state(struct
> drm_i915_private *dev_priv,
> hw_state->pll3 = I915_READ(BXT_PORT_PLL(port, 3));
> hw_state->pll6 = I915_READ(BXT_PORT_PLL(port, 6));
> hw_state->pll8 = I915_READ(BXT_PORT_PLL(port, 8));
> + hw_state->pll10 = I915_READ(BXT_PORT_PLL(port, 10));
> /*
> * While we write to the group register to program all lanes at once we
> * can read only lane registers. We configure all lanes the same way, so
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
