The specs refer to pin pairs. Start moving towards using pin rather than
port all around to avoid confusion. No functional changes.
Signed-off-by: Jani Nikula <jani.nik...@intel.com>
---
drivers/gpu/drm/i915/i915_drv.h | 2 +-
drivers/gpu/drm/i915/i915_reg.h | 20 ++++++++++----------
drivers/gpu/drm/i915/intel_bios.c | 2 +-
drivers/gpu/drm/i915/intel_crt.c | 2 +-
drivers/gpu/drm/i915/intel_dvo.c | 8 ++++----
drivers/gpu/drm/i915/intel_hdmi.c | 8 ++++----
drivers/gpu/drm/i915/intel_lvds.c | 2 +-
drivers/gpu/drm/i915/intel_sdvo.c | 2 +-
8 files changed, 23 insertions(+), 23 deletions(-)
diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
index 256369f29975..a1d9d302278f 100644
--- a/drivers/gpu/drm/i915/i915_drv.h
+++ b/drivers/gpu/drm/i915/i915_drv.h
@@ -3051,7 +3051,7 @@ extern int intel_setup_gmbus(struct drm_device *dev);
extern void intel_teardown_gmbus(struct drm_device *dev);
static inline bool intel_gmbus_is_port_valid(unsigned port)
{
- return (port >= GMBUS_PORT_SSC && port <= GMBUS_PORT_DPD);
+ return (port >= GMBUS_PIN_SSC && port <= GMBUS_PIN_DPD);
}
extern struct i2c_adapter *intel_gmbus_get_adapter(
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index b522eb6e59a4..b6113c9a803b 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -1788,16 +1788,16 @@ enum skl_disp_power_wells {
#define GMBUS_RATE_400KHZ (2<<8) /* reserved on Pineview */
#define GMBUS_RATE_1MHZ (3<<8) /* reserved on Pineview */
#define GMBUS_HOLD_EXT (1<<7) /* 300ns hold time, rsvd on Pineview */
-#define GMBUS_PORT_DISABLED 0
-#define GMBUS_PORT_SSC 1
-#define GMBUS_PORT_VGADDC 2
-#define GMBUS_PORT_PANEL 3
-#define GMBUS_PORT_DPD_CHV 3 /* HDMID_CHV */
-#define GMBUS_PORT_DPC 4 /* HDMIC */
-#define GMBUS_PORT_DPB 5 /* SDVO, HDMIB */
-#define GMBUS_PORT_DPD 6 /* HDMID */
-#define GMBUS_PORT_RESERVED 7 /* 7 reserved */
-#define GMBUS_NUM_PORTS (GMBUS_PORT_DPD - GMBUS_PORT_SSC + 1)
+#define GMBUS_PIN_DISABLED 0
+#define GMBUS_PIN_SSC 1
+#define GMBUS_PIN_VGADDC 2
+#define GMBUS_PIN_PANEL 3
+#define GMBUS_PIN_DPD_CHV 3 /* HDMID_CHV */
+#define GMBUS_PIN_DPC 4 /* HDMIC */
+#define GMBUS_PIN_DPB 5 /* SDVO, HDMIB */
+#define GMBUS_PIN_DPD 6 /* HDMID */
+#define GMBUS_PIN_RESERVED 7 /* 7 reserved */
+#define GMBUS_NUM_PORTS (GMBUS_PIN_DPD - GMBUS_PIN_SSC + 1)
#define GMBUS1 0x5104 /* command/status */
#define GMBUS_SW_CLR_INT (1<<31)
#define GMBUS_SW_RDY (1<<30)
diff --git a/drivers/gpu/drm/i915/intel_bios.c
b/drivers/gpu/drm/i915/intel_bios.c
index c684085cb56a..40c8375a4477 100644
--- a/drivers/gpu/drm/i915/intel_bios.c
+++ b/drivers/gpu/drm/i915/intel_bios.c
@@ -1133,7 +1133,7 @@ init_vbt_defaults(struct drm_i915_private *dev_priv)
struct drm_device *dev = dev_priv->dev;
enum port port;
- dev_priv->vbt.crt_ddc_pin = GMBUS_PORT_VGADDC;
+ dev_priv->vbt.crt_ddc_pin = GMBUS_PIN_VGADDC;
/* Default to having backlight */
dev_priv->vbt.backlight.present = true;
diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c
index 573aaff3389a..61a174db8a89 100644
--- a/drivers/gpu/drm/i915/intel_crt.c
+++ b/drivers/gpu/drm/i915/intel_crt.c
@@ -745,7 +745,7 @@ static int intel_crt_get_modes(struct drm_connector
*connector)
goto out;
/* Try to probe digital port for output in DVI-I -> VGA mode. */
- i2c = intel_gmbus_get_adapter(dev_priv, GMBUS_PORT_DPB);
+ i2c = intel_gmbus_get_adapter(dev_priv, GMBUS_PIN_DPB);
ret = intel_crt_ddc_get_modes(connector, i2c);
out:
diff --git a/drivers/gpu/drm/i915/intel_dvo.c b/drivers/gpu/drm/i915/intel_dvo.c
index 4ccd6c3f133d..fe13bbbf301c 100644
--- a/drivers/gpu/drm/i915/intel_dvo.c
+++ b/drivers/gpu/drm/i915/intel_dvo.c
@@ -80,7 +80,7 @@ static const struct intel_dvo_device intel_dvo_devices[] = {
.name = "ch7017",
.dvo_reg = DVOC,
.slave_addr = 0x75,
- .gpio = GMBUS_PORT_DPB,
+ .gpio = GMBUS_PIN_DPB,
.dev_ops = &ch7017_ops,
},
{
@@ -364,7 +364,7 @@ static int intel_dvo_get_modes(struct drm_connector
*connector)
* that's not the case.
*/
intel_ddc_get_modes(connector,
- intel_gmbus_get_adapter(dev_priv, GMBUS_PORT_DPC));
+ intel_gmbus_get_adapter(dev_priv, GMBUS_PIN_DPC));
if (!list_empty(&connector->probed_modes))
return 1;
@@ -503,9 +503,9 @@ void intel_dvo_init(struct drm_device *dev)
if (intel_gmbus_is_port_valid(dvo->gpio))
gpio = dvo->gpio;
else if (dvo->type == INTEL_DVO_CHIP_LVDS)
- gpio = GMBUS_PORT_SSC;
+ gpio = GMBUS_PIN_SSC;
else
- gpio = GMBUS_PORT_DPB;
+ gpio = GMBUS_PIN_DPB;
/* Set up the I2C bus necessary for the chip we're probing.
* It appears that everything is on GPIOE except for panels
diff --git a/drivers/gpu/drm/i915/intel_hdmi.c
b/drivers/gpu/drm/i915/intel_hdmi.c
index cacbafdad3ab..26222e6c1ff3 100644
--- a/drivers/gpu/drm/i915/intel_hdmi.c
+++ b/drivers/gpu/drm/i915/intel_hdmi.c
@@ -1681,18 +1681,18 @@ void intel_hdmi_init_connector(struct
intel_digital_port *intel_dig_port,
switch (port) {
case PORT_B:
- intel_hdmi->ddc_bus = GMBUS_PORT_DPB;
+ intel_hdmi->ddc_bus = GMBUS_PIN_DPB;
intel_encoder->hpd_pin = HPD_PORT_B;
break;
case PORT_C:
- intel_hdmi->ddc_bus = GMBUS_PORT_DPC;
+ intel_hdmi->ddc_bus = GMBUS_PIN_DPC;
intel_encoder->hpd_pin = HPD_PORT_C;
break;
case PORT_D:
if (IS_CHERRYVIEW(dev))
- intel_hdmi->ddc_bus = GMBUS_PORT_DPD_CHV;
+ intel_hdmi->ddc_bus = GMBUS_PIN_DPD_CHV;
else
- intel_hdmi->ddc_bus = GMBUS_PORT_DPD;
+ intel_hdmi->ddc_bus = GMBUS_PIN_DPD;
intel_encoder->hpd_pin = HPD_PORT_D;
break;
case PORT_A:
diff --git a/drivers/gpu/drm/i915/intel_lvds.c
b/drivers/gpu/drm/i915/intel_lvds.c
index 06d2da336f7c..875916152645 100644
--- a/drivers/gpu/drm/i915/intel_lvds.c
+++ b/drivers/gpu/drm/i915/intel_lvds.c
@@ -921,7 +921,7 @@ void intel_lvds_init(struct drm_device *dev)
if (dmi_check_system(intel_no_lvds))
return;
- pin = GMBUS_PORT_PANEL;
+ pin = GMBUS_PIN_PANEL;
if (!lvds_is_present_in_vbt(dev, &pin)) {
DRM_DEBUG_KMS("LVDS is not present in VBT\n");
return;
diff --git a/drivers/gpu/drm/i915/intel_sdvo.c
b/drivers/gpu/drm/i915/intel_sdvo.c
index f5b7e1e7c5e0..3e0e9b0e3503 100644
--- a/drivers/gpu/drm/i915/intel_sdvo.c
+++ b/drivers/gpu/drm/i915/intel_sdvo.c
@@ -2294,7 +2294,7 @@ intel_sdvo_select_i2c_bus(struct drm_i915_private
*dev_priv,
if (mapping->initialized && intel_gmbus_is_port_valid(mapping->i2c_pin))
pin = mapping->i2c_pin;
else
- pin = GMBUS_PORT_DPB;
+ pin = GMBUS_PIN_DPB;
sdvo->i2c = intel_gmbus_get_adapter(dev_priv, pin);
--
2.1.4
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
