From: Ville Syrjälä <ville.syrj...@linux.intel.com>

Currently the logic to fix up the frame counter on gen3/4 assumes that
start of vblank occurs at vblank_start*htotal pixels, when in fact
it occurs htotal-hsync_start pixels earlier. Apply the appropriate
adjustment to make the frame counter more accurate.

Also fix the vblank start position for interlaced display modes.

Signed-off-by: Ville Syrjälä <ville.syrj...@linux.intel.com>
---
 drivers/gpu/drm/i915/i915_irq.c | 21 ++++++++++++++++-----
 1 file changed, 16 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
index 9f1c449..fc49fb6 100644
--- a/drivers/gpu/drm/i915/i915_irq.c
+++ b/drivers/gpu/drm/i915/i915_irq.c
@@ -639,7 +639,7 @@ static u32 i915_get_vblank_counter(struct drm_device *dev, 
int pipe)
        drm_i915_private_t *dev_priv = (drm_i915_private_t *) dev->dev_private;
        unsigned long high_frame;
        unsigned long low_frame;
-       u32 high1, high2, low, pixel, vbl_start;
+       u32 high1, high2, low, pixel, vbl_start, hsync_start, htotal;
 
        if (!i915_pipe_enabled(dev, pipe)) {
                DRM_DEBUG_DRIVER("trying to get vblank count for disabled "
@@ -653,17 +653,28 @@ static u32 i915_get_vblank_counter(struct drm_device 
*dev, int pipe)
                const struct drm_display_mode *mode =
                        &intel_crtc->config.adjusted_mode;
 
-               vbl_start = mode->crtc_vblank_start * mode->crtc_htotal;
+               htotal = mode->crtc_htotal;
+               hsync_start = mode->crtc_hsync_start;
+               vbl_start = mode->crtc_vblank_start;
+               if (mode->flags & DRM_MODE_FLAG_INTERLACE)
+                       vbl_start = DIV_ROUND_UP(vbl_start, 2);
        } else {
                enum transcoder cpu_transcoder = (enum transcoder) pipe;
-               u32 htotal;
 
                htotal = ((I915_READ(HTOTAL(cpu_transcoder)) >> 16) & 0x1fff) + 
1;
+               hsync_start = (I915_READ(HSYNC(cpu_transcoder))  & 0x1fff) + 1;
                vbl_start = (I915_READ(VBLANK(cpu_transcoder)) & 0x1fff) + 1;
-
-               vbl_start *= htotal;
+               if ((I915_READ(PIPECONF(cpu_transcoder)) &
+                    PIPECONF_INTERLACE_MASK) != PIPECONF_PROGRESSIVE)
+                       vbl_start = DIV_ROUND_UP(vbl_start, 2);
        }
 
+       /* Convert to pixel count */
+       vbl_start *= htotal;
+
+       /* Start of vblank event occurs at start of hsync */
+       vbl_start -= htotal - hsync_start;
+
        high_frame = PIPEFRAME(pipe);
        low_frame = PIPEFRAMEPIXEL(pipe);
 
-- 
1.8.3.2

_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx

Reply via email to