On 7/20/2021 12:28 AM, Navare, Manasi wrote:
On Mon, Jul 19, 2021 at 11:47:51AM +0530, Nautiyal, Ankit K wrote:
Patch looks good to me.

Please find below some suggestions

On 7/15/2021 4:04 AM, Manasi Navare wrote:
Currently when we do the HW state readout, we dont set the shared dpll to NULL
for the bigjoiner slave which should not have a DPLL assigned. So it has
some garbage while the HW state readout is NULL. So explicitly reset
the shared dpll for bigjoiner slave pipe.

Bug: https://gitlab.freedesktop.org/drm/intel/-/issues/3465
Cc: Ville Syrjälä <ville.syrj...@linux.intel.com>
Cc: Ankit Nautiyal <ankit.k.nauti...@intel.com>
Tested-By: Swati Sharma <swati2.sha...@intel.com>
checkpatch warning about tested-by tag.
Signed-off-by: Manasi Navare <manasi.d.nav...@intel.com>
---
  drivers/gpu/drm/i915/display/intel_display.c | 4 ++++
  1 file changed, 4 insertions(+)

diff --git a/drivers/gpu/drm/i915/display/intel_display.c 
b/drivers/gpu/drm/i915/display/intel_display.c
index 65ddb6ca16e6..c274bfb8e549 100644
--- a/drivers/gpu/drm/i915/display/intel_display.c
+++ b/drivers/gpu/drm/i915/display/intel_display.c
@@ -9006,6 +9006,10 @@ verify_crtc_state(struct intel_crtc *crtc,
        if (!new_crtc_state->hw.active)
                return;
+       if (new_crtc_state->bigjoiner_slave)
+               /* No PLLs set for slave */
+               pipe_config->shared_dpll = NULL;
+
there is a check for bigjoiner_slave, couple of lines above this:

if (new_crtc_state->bigjoiner_slave)
                 master = new_crtc_state->bigjoiner_linked_crtc;

Perhaps it will make sense to club the set shared_dpll to NULL, along with
these lines.
Yup, thats where I was resetting in earlier patch but then it actually gets 
overridden in a function call
after this point so need to reset it after separately.

Manasi

You are right. I missed that, pipe_config gets overwritten just before this point, so the change is at the right place.

Regards,

Ankit



In any case:

Reviewed-by: Ankit Nautiyal <ankit.k.nauti...@intel.com>

        intel_pipe_config_sanity_check(dev_priv, pipe_config);
        if (!intel_pipe_config_compare(new_crtc_state,
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx

Reply via email to