On Fri, Jan 29, 2021 at 07:06:33PM +0200, Imre Deak wrote:
> On Thu, Jan 28, 2021 at 05:59:46PM +0200, Ville Syrjala wrote:
> > From: Ville Syrjälä <ville.syrj...@linux.intel.com>
> > 
> > Currently we only explicitly power up the combo PHY lanes
> > for DP. The spec says we should do it for HDMI as well.
> > 
> > Cc: sta...@vger.kernel.org
> > Signed-off-by: Ville Syrjälä <ville.syrj...@linux.intel.com>
> > ---
> >  drivers/gpu/drm/i915/display/intel_ddi.c | 2 ++
> >  1 file changed, 2 insertions(+)
> > 
> > diff --git a/drivers/gpu/drm/i915/display/intel_ddi.c 
> > b/drivers/gpu/drm/i915/display/intel_ddi.c
> > index 88cc6e2fbe91..8fbeb8c24efb 100644
> > --- a/drivers/gpu/drm/i915/display/intel_ddi.c
> > +++ b/drivers/gpu/drm/i915/display/intel_ddi.c
> > @@ -4337,6 +4337,8 @@ static void intel_enable_ddi_hdmi(struct 
> > intel_atomic_state *state,
> >             intel_de_write(dev_priv, reg, val);
> >     }
> >  
> > +   intel_ddi_power_up_lanes(encoder, crtc_state);
> > +
> 
> Not sure if it matters, but the spec says to apply WA #1143 just before
> enabling DDI_BUF_CTL.

intel_ddi_power_up_lanes() is a nop for pre-icl, so we still do that.
Also not sure what the final fate of that w/a will be since apparently
it's not working as intended.

That said I was debating with myself what order to put these in, but
in the end I chose this order because the w/a is related to the
vswing programming, and so wanted to keep it next to the BUF_TRANS
programming.

> 
> 
> >     /* In HDMI/DVI mode, the port width, and swing/emphasis values
> >      * are ignored so nothing special needs to be done besides
> >      * enabling the port.
> > -- 
> > 2.26.2
> > 
> > _______________________________________________
> > Intel-gfx mailing list
> > Intel-gfx@lists.freedesktop.org
> > https://lists.freedesktop.org/mailman/listinfo/intel-gfx

-- 
Ville Syrjälä
Intel
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx

Reply via email to