Bspec for the "DPLL HDMI multiplier" field says:
"Restriction : The DPLL must be enabled and stable before setting these bits.
These bits must be programmed after DPLL_SEL is programmed."
There is apparently no restriction on programming the DPLL_SEL
register wrt the DPLL. So let's just move that up before we enable the
pch dpll.
Signed-off-by: Daniel Vetter <daniel.vet...@ffwll.ch>
---
drivers/gpu/drm/i915/intel_display.c | 20 +++++++++++---------
1 file changed, 11 insertions(+), 9 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_display.c
b/drivers/gpu/drm/i915/intel_display.c
index 0917fb1..9f1247f 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -2929,15 +2929,8 @@ static void ironlake_pch_enable(struct drm_crtc *crtc)
/* For PCH output, training FDI link */
dev_priv->display.fdi_link_train(crtc);
- /* XXX: pch pll's can be enabled any time before we enable the PCH
- * transcoder, and we actually should do this to not upset any PCH
- * transcoder that already use the clock when we share it.
- *
- * Note that enable_shared_dpll tries to do the right thing, but
- * get_shared_dpll unconditionally resets the pll - we need that to have
- * the right LVDS enable sequence. */
- ironlake_enable_shared_dpll(intel_crtc);
-
+ /* We need to program the right clock selection before writing the pixel
+ * mutliplier into the DPLL. */
if (HAS_PCH_CPT(dev)) {
u32 sel;
@@ -2951,6 +2944,15 @@ static void ironlake_pch_enable(struct drm_crtc *crtc)
I915_WRITE(PCH_DPLL_SEL, temp);
}
+ /* XXX: pch pll's can be enabled any time before we enable the PCH
+ * transcoder, and we actually should do this to not upset any PCH
+ * transcoder that already use the clock when we share it.
+ *
+ * Note that enable_shared_dpll tries to do the right thing, but
+ * get_shared_dpll unconditionally resets the pll - we need that to have
+ * the right LVDS enable sequence. */
+ ironlake_enable_shared_dpll(intel_crtc);
+
/* set transcoder timing, panel must allow it */
assert_panel_unlocked(dev_priv, pipe);
ironlake_pch_transcoder_set_timings(intel_crtc, pipe);
--
1.7.11.7
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
