On Thu, Jul 18, 2019 at 05:43:39PM +0300, Ville Syrjala wrote:
> From: Ville Syrjälä <ville.syrj...@linux.intel.com>
>
> The DP port/pipe goes wonky if we try to use timings with
> hdisplay==4096 on pre-HSW platforms. The link fails to train
> and the pipe may not signal vblank interrupts. On HDMI such at
> mode works just fine (tested on ELK/SNB/CHV). So let's refuse
> such modes on DP on older platforms.
>
> Signed-off-by: Ville Syrjälä <ville.syrj...@linux.intel.com>
Makes sense if the link is not able to get trained that we reject this mode
> ---
> drivers/gpu/drm/i915/display/intel_dp.c | 25 +++++++++++++++++++++++++
> 1 file changed, 25 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
> b/drivers/gpu/drm/i915/display/intel_dp.c
> index 0eb5d66f87a7..c96030761eae 100644
> --- a/drivers/gpu/drm/i915/display/intel_dp.c
> +++ b/drivers/gpu/drm/i915/display/intel_dp.c
> @@ -493,6 +493,25 @@ int intel_dp_get_link_train_fallback_values(struct
> intel_dp *intel_dp,
> return 0;
> }
>
> +static bool intel_dp_hdisplay_bad(struct drm_i915_private *dev_priv,
> + int hdisplay)
> +{
> + /*
> + * Older platforms don't like hdisplay==4096 with DP.
> + *
> + * On ILK/SNB/IVB the pipe seems to be somewhat running (scanline
> + * and frame counter increment), but we don't get vblank interrupts,
> + * and the pipe underruns immediately. The link also doesn't seem
> + * to get trained properly.
> + *
> + * On CHV the vblank interrupts don't seem to disappear but
> + * otherwise the symptoms are similar.
> + *
> + * TODO: confirm the behaviour on HSW+
> + */
> + return hdisplay == 4096 && !HAS_DDI(dev_priv);
> +}
> +
> static enum drm_mode_status
> intel_dp_mode_valid(struct drm_connector *connector,
> struct drm_display_mode *mode)
> @@ -528,6 +547,9 @@ intel_dp_mode_valid(struct drm_connector *connector,
> max_rate = intel_dp_max_data_rate(max_link_clock, max_lanes);
> mode_rate = intel_dp_link_required(target_clock, 18);
>
> + if (intel_dp_hdisplay_bad(dev_priv, mode->hdisplay))
> + return MODE_H_ILLEGAL;
> +
> /*
> * Output bpp is stored in 6.4 format so right shift by 4 to get the
> * integer value since we support only integer values of bpp.
> @@ -2208,6 +2230,9 @@ intel_dp_compute_config(struct intel_encoder *encoder,
> if (adjusted_mode->flags & DRM_MODE_FLAG_DBLCLK)
> return -EINVAL;
>
> + if (intel_dp_hdisplay_bad(dev_priv, adjusted_mode->crtc_hdisplay))
> + return -EINVAL;
Why would we need another check in compute_config() since the mode would have
been
rejected already in intel_dp_mode_valid()
Manasi
> +
> ret = intel_dp_compute_link_config(encoder, pipe_config, conn_state);
> if (ret < 0)
> return ret;
> --
> 2.21.0
>
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx@lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
