On Thu, Jan 17, 2013 at 12:45:18PM -0800, Ben Widawsky wrote:
> Similar to gtt_mappable_entries we don't usually want the entries,
> it's easy enough to calculate it when you need.
> 
> v2: Move relevant fields above pre-gen6 init
> 
> Reviewed-by: Rodrigo Vivi <rodrigo.v...@gmail.com>
> Signed-off-by: Ben Widawsky <b...@bwidawsk.net>

[snip]

> @@ -687,11 +690,18 @@ int i915_gem_gtt_init(struct drm_device *dev)
>  {
>       struct drm_i915_private *dev_priv = dev->dev_private;
>       phys_addr_t gtt_bus_addr;
> +     u32 gtt_size;
>       u16 snb_gmch_ctl;
>       int ret;
>  
> +     if (!pci_set_dma_mask(dev->pdev, DMA_BIT_MASK(40)))
> +             pci_set_consistent_dma_mask(dev->pdev, DMA_BIT_MASK(40));
> +
> +     pci_read_config_word(dev->pdev, SNB_GMCH_CTRL, &snb_gmch_ctl);
>       dev_priv->gtt.mappable_base = pci_resource_start(dev->pdev, 2);
>       dev_priv->gtt.mappable_end = pci_resource_len(dev->pdev, 2);
> +     gtt_size = gen6_get_total_gtt_size(snb_gmch_ctl);

Calculating gtt size like this doesn't work too well on pre-gen6.
-Daniel
-- 
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx

Reply via email to