On Mon, Jan 09, 2012 at 09:22:47AM -0800, Keith Packard wrote:
> On Mon, 9 Jan 2012 21:17:17 +0800, Wu Fengguang <fengguang...@intel.com>
> wrote:
>
> > +#define IBX_AUD_CONFIG_A 0xe2000
> > +#define CPT_AUD_CONFIG_A 0xe5000
>
> These register addresses match the docs.
>
> > + I915_WRITE(aud_config, 1 << 29); /* N value index, 0x1 = DP */
>
> Please don't use constants here, instead add #defines for all of the
> bits in this new register, in case someone else needs to use the
> register later.
OK. Updated patch to use macro as follows.
> Do we also need to program the pixel clock values in this register?
The pixel clock value is only for HDMI. I'd not touch this as long as
it works fine ;)
Thanks,
Fengguang
---
Subject: drm/i915: set AUD_CONFIG N_value_index for DisplayPort
Date: Fri Jan 06 14:41:31 CST 2012
It should be programmed to "0" for HDMI or "1" for DisplayPort.
This enables DisplayPort audio for
- HP EliteBook 8460p
(whose BIOS does not set the N_value_index bit for us)
- DisplayPort monitor hot plugged after boot
(otherwise most BIOS will fill the N_value_index bit for us)
Tested-by: Robert Lemaire <rlema...@suse.com>
Signed-off-by: Wu Fengguang <fengguang...@intel.com>
---
drivers/gpu/drm/i915/i915_reg.h | 12 ++++++++++++
drivers/gpu/drm/i915/intel_display.c | 5 +++++
2 files changed, 17 insertions(+)
--- linux.orig/drivers/gpu/drm/i915/i915_reg.h 2012-01-07 23:11:10.000000000
+0800
+++ linux/drivers/gpu/drm/i915/i915_reg.h 2012-01-10 13:20:17.000000000
+0800
@@ -3582,4 +3582,16 @@
#define CPT_AUD_CNTL_ST_A 0xE50B4
#define CPT_AUD_CNTRL_ST2 0xE50C0
+#define IBX_AUD_CONFIG_A 0xe2000
+#define CPT_AUD_CONFIG_A 0xe5000
+#define AUD_CONFIG_N_VALUE_INDEX (1 << 29)
+#define AUD_CONFIG_N_PROG_ENABLE (1 << 28)
+#define AUD_CONFIG_UPPER_N_SHIFT 20
+#define AUD_CONFIG_UPPER_N_VALUE (0xff << 20)
+#define AUD_CONFIG_LOWER_N_SHIFT 4
+#define AUD_CONFIG_LOWER_N_VALUE (0xfff << 4)
+#define AUD_CONFIG_PIXEL_CLOCK_HDMI_SHIFT 16
+#define AUD_CONFIG_PIXEL_CLOCK_HDMI (0xf << 16)
+#define AUD_CONFIG_DISABLE_NCTS (1 << 3)
+
#endif /* _I915_REG_H_ */
--- linux.orig/drivers/gpu/drm/i915/intel_display.c 2012-01-07
23:11:10.000000000 +0800
+++ linux/drivers/gpu/drm/i915/intel_display.c 2012-01-10 13:23:25.000000000
+0800
@@ -5908,15 +5908,18 @@ static void ironlake_write_eld(struct dr
uint32_t i;
int len;
int hdmiw_hdmiedid;
+ int aud_config;
int aud_cntl_st;
int aud_cntrl_st2;
if (HAS_PCH_IBX(connector->dev)) {
hdmiw_hdmiedid = IBX_HDMIW_HDMIEDID_A;
+ aud_config = IBX_AUD_CONFIG_A;
aud_cntl_st = IBX_AUD_CNTL_ST_A;
aud_cntrl_st2 = IBX_AUD_CNTL_ST2;
} else {
hdmiw_hdmiedid = CPT_HDMIW_HDMIEDID_A;
+ aud_config = CPT_AUD_CONFIG_A;
aud_cntl_st = CPT_AUD_CNTL_ST_A;
aud_cntrl_st2 = CPT_AUD_CNTRL_ST2;
}
@@ -5924,6 +5927,7 @@ static void ironlake_write_eld(struct dr
i = to_intel_crtc(crtc)->pipe;
hdmiw_hdmiedid += i * 0x100;
aud_cntl_st += i * 0x100;
+ aud_config += i * 0x100;
DRM_DEBUG_DRIVER("ELD on pipe %c\n", pipe_name(i));
@@ -5943,6 +5947,7 @@ static void ironlake_write_eld(struct dr
if (intel_pipe_has_type(crtc, INTEL_OUTPUT_DISPLAYPORT)) {
DRM_DEBUG_DRIVER("ELD: DisplayPort detected\n");
eld[5] |= (1 << 2); /* Conn_Type, 0x1 = DisplayPort */
+ I915_WRITE(aud_config, AUD_CONFIG_N_VALUE_INDEX); /* 0x1 = DP */
}
if (intel_eld_uptodate(connector,
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
