> the xinetd.conf in case of Telnet is not correct.
> In RHL 7.x , during install, the firewall setup specifically mentions
> blocking the telnet port. If you choose to do a custom configure of the
> firewall, you can enable the telnet port. Therefore, its ipchains which is
> blocking access to telnet.
I never faced this problem, because i always use a custom ipchains script to
set up the firewall. But thanks anyways for pointing this out.
Bye,
/\ |\/| |3 /\ r
================================================
To un/subscribe, send email to [EMAIL PROTECTED] with 'un/subscribe' in subject
header
Archives are available at http://www.mail-archive.com/ilugd%40wpaa.org
=================================================
