On Mon, Mar 2, 2009 at 2:45 PM, arun kumar <arun_kris...@yahoo.co.in> wrote: > I want to learn embedded in linux with arm controller.
Do you have prior experience in Programming hardware? Else I would suggest you start with smaller MicroController and get used to programming hardware first and gradually go up the ladder. Starting with ARM is not exactly something I would recommend/suggest. > Is there any arm based free compiler in linux, which supports arm7 & arm9. http://www.gnuarm.com/ (Tools also On emdebian repos) > And I need some sample codes for that compiler. And Is there any limitations > for that compiler. Sample code? There is always the standard Hello World that you can write and try it out to see your setup is working fine. Limitations of the compiler is very abstract thing. It depends on a lot of factors and unless you want to dig deep into tool chain development and stuff, I don't think one generally need to worry at this factor (especially if you are just beginning to do embedded development) You can check out http://fpga4u.epfl.ch/wiki/FPGA4U_Description (it costs about 4500 INR and also with additional cost of say 1000 INR you get an ARM board extension) You can do a lot of stuff with this student board. Not a promotion, but I can try to get one down if you need it when I come to India (I am not confirming it though as I need to check with a lot of folks) Regards, Aanjhan _______________________________________________ To unsubscribe, email ilugc-requ...@ae.iitm.ac.in with "unsubscribe <password> <address>" in the subject or body of the message. http://www.ae.iitm.ac.in/mailman/listinfo/ilugc
