Most if not all the changes I have done with the SET Command. The one I have always Changed is the LNKLST, however I have always been very careful to LNKLST for the next IPL. Otherwise you are doomed to keep redoing the change.
-----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Jason Cai Sent: Tuesday, December 17, 2019 11:48 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: how to compare active parameter with the parameter in member Hi all After some paramters were changed dynamically , these paremeters didn't be changed in members . Next IPL, we will lost these changes. Is there any way to compare active parameters with the parameters in members? Any thoughts/comments/suggestions would be greatly appreciated Best Regards, Jason Cai ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
