I don't recall having SAD stall in any kind of 'restartable' state. In general, 
if you restart (reIPL) SAD, you'll likely get a dump of SAD itself because 
that's the 'OS' in control. The resulting dump may help you figure out what's 
wrong with SAD but will probably not help much with the original problem that 
inspired SAD in the first place.

I suggest configuring SAD to use only disk, not tape. Over the years most 
problems I've encountered have involved tape. Also do not prompt the operator 
to enter *anything*; that's the other common cause of failure. A 'properly' 
configured SAD should run from start to finish without any manual intervention. 
 

-----Original Message-----
From: IBM Mainframe Discussion List <IBM-MAIN@LISTSERV.UA.EDU> On Behalf Of 
NandhaKumar S
Sent: Monday, September 9, 2019 11:46 AM
To: IBM-MAIN@LISTSERV.UA.EDU
Subject: (External):How to restart SADMP

Hi Team,

How to restart SADMP if it’s stuck after Loaded SAD profile? IBM suggested the 
Procedure-B to restart the SADMP But I don’t want to Re-IPL the SADMP.

Let me know if someone have faced this issue.

Thanks, Nandha


----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN

Reply via email to