Again: The APF command is NOT failing, it 'just' does not show on the main panel! It only shows *after* the APF command was *successfully* executed! And then only for as long as I stay within that session.
With the exception of 4 userids, *everybody* is in ISFUSER, which doesn't mean anything because the authorized functions are explicitly enabled via RACF. The LNK command shows up just fine. GROUP.ISFUSER.** and ISF.CONNECT.** are enabled/defined for the group in question. I just defined a new (test) user and connected it to a group known to work, and the APF command is executable there without problem, but also does not show up on the primary panel until the command has been successfully executed once in that SDSF session. Again, the LNK command shows up fine before and after execution. If I permit the group to the LINE command (just to test something else), it also shows up on the primary panel. Barbara ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
