On Fri, 10 Aug 2018 13:26:00 +0000, Allan Staller <allan.stal...@hcl.com> wrote:
>Nope. This can only be changed by command. JES2 will remember prior settings >until changed via command. > >$TJOBCLASS(*),SWA=ABOVE >$TJOBCLASS(STC),SWA=ABOVE <----- >$TJOBCLASS(TSU),SWA=ABOVE > >It sounds (to me) like someone issue the command previously and reality and >JESPARM have gotten out of sync. > I can't believe $T JOBCLASS commands will affect STCs started before JES2 was up, or started by subsystems other than JES2. >-----Original Message----- >From: IBM Mainframe Discussion List <IBM-MAIN@LISTSERV.UA.EDU> On Behalf Of >Giliad Wilf >Sent: Friday, August 10, 2018 8:19 AM >To: IBM-MAIN@LISTSERV.UA.EDU >Subject: MSG IEFA111I SWA=BELOW,TIOT SIZE=32K,DSENQSHR=DISALLOW,GDGBIAS=JOB > >Hi All, Observing a z/OS 2.3 start-up of a new system, I can see a lot of >these messages,all of which state "SWA=BELOW". >All our JES2 jobclasses specify "SWA=ABOVE, but these messages are issued >forSTCs invoked before JES2 start-up, or for STCs managed by subsystems other >thanJES2. > AFAIK, SWA location can be set by IEFUJV, which is roughly SR 15,15 plus BR > 14 on our vanilla system. Is there a way to control SWA location for such > STCs without writing a site IEFUJV? Maybe a PARMLIB member, such as ALLOCxx? > Regards, > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
