Whenever I look at CAS abends: If the offset is close, and the symptoms match, then I usually find the apar as matching close enough 106c vs 1070 - to me it is close enough
Do you know if the symptoms in the apar are what was going on when the S0C4 occurred? That would be the only way to know. Otherwise the dump would need to be reviewed by IBM Catalog support. Since this is z/OS V1.13 - and off support, probably this would be the best they could do. But they do have access to more entries than you or I would through IBM LINK I would be less likely to think it may be a match if the byte different is over 100 but under 100 - it is a possibility Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Peter > Sent: Wednesday, February 28, 2018 10:19 PM > To: [email protected] > Subject: Re: Job abended in CAS > > Is this same case with this as the offset value differs ..? > > On 01-Mar-2018 10:39 AM, "Lizette Koehler" <[email protected]> wrote: > > > I would go into IBMLINK and use the module name and FMID In the search > > > > IGG0CLFG HDZ1D10 > > > > You may come across APAR . OA45158 > > > > > > Lizette > > > > > > > -----Original Message----- > > > From: IBM Mainframe Discussion List > > > [mailto:[email protected]] On Behalf Of Lizette Koehler > > > Sent: Wednesday, February 28, 2018 10:06 PM > > > To: [email protected] > > > Subject: Re: Job abended in CAS > > > > > > This is going to be an issue. > > > > > > z/OS V1.13 is way off support. You could open a PMR/SR but IBM could > > > only look to see if there were any apars for that specific issue. > > > > > > Have you looked in IBMLINK to see if there are any apars that match > > > your issue? > > > > > > Lizette > > > > > > > > > > -----Original Message----- > > > > From: IBM Mainframe Discussion List > > > > [mailto:[email protected]] On Behalf Of Peter > > > > Sent: Wednesday, February 28, 2018 9:57 PM > > > > To: [email protected] > > > > Subject: Job abended in CAS > > > > > > > > Hi > > > > > > > > One of our schedule Job abended with below > > > > > > > > ABEND0C4 IGG0CLGF +106C FMID=HDZ1D10 MAINT=UA68225 > > > > > > > > We are at zOS 1.13 > > > > > > > > Not able to find a Google hit on the above offset > > > > > > > > Anyone have faced a similar issue ? > > > > > > > > Peter > > > > > > > > ------------------------------------------------------------------ > > > > ---- For IBM-MAIN subscribe / signoff / archive access > > > > instructions, send email to [email protected] with the > > > > message: INFO IBM-MAIN > > > > > > -------------------------------------------------------------------- > > > -- For IBM-MAIN subscribe / signoff / archive access instructions, > > > send > > email to > > > [email protected] with the message: INFO IBM-MAIN > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, send > > email to [email protected] with the message: INFO IBM-MAIN > > > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email to > [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
