I actually know nada but doubt the need for an IPL. More likely a "smaller" problem. Can you post the mini-dump?
CharlesSent from a mobile; please excuse the brevity. -------- Original message --------From: Mark Pace <[email protected]> Date: 9/22/17 10:32 PM (GMT+01:00) To: [email protected] Subject: CBT FILE019 - Command - 0C4 I installed the CBT FILE019 - Command. There were no special instructions, except that program had to be APF authorized. So I did an assemble and link edit into a library that is APF authorized. I then did a F LLA,REFRESH. But when I run the program I get an 0C4. SYSTEM COMPLETION CODE=0C4 REASON CODE=00000004 I'm not sure if the LLA,REFRESH was enough. I think I may try to IPL. Any ideas? This is 2.2 system. -- The postings on this site are my own and don’t necessarily represent Mainline’s positions or opinions Mark D Pace Senior Systems Engineer Mainline Information Systems ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
