I just realized there was an entry for the x'17' 0C 17 The MVS™ message service is unavailable.
Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Lizette Koehler > Sent: Wednesday, May 11, 2016 12:18 PM > To: [email protected] > Subject: Re: NXBRIDGE (TPV) > > You may wish to contact the vendor support for this. > > But looking up the IKJ55365I message, it directs to the Assembler Program > manual for TRANMSG > > Under TRANMSG it says for a 0C RC. > > 0C Processing ended prematurely. The output is unusable. Possible causes > are: > > You have attempted to translate too many messages at one time. > The MIO is not valid > The output buffer is too small for any messages. > > HTH > > Lizette > > > > > -----Original Message----- > > From: IBM Mainframe Discussion List [mailto:[email protected]] > > On Behalf Of Michael Rooker > > Sent: Wednesday, May 11, 2016 9:17 AM > > To: [email protected] > > Subject: NXBRIDGE (TPV) > > > > Hi, > > > > > > Anybody running NXBRIDGE ? > > > > We see below messages on NXBRIDGE stc on one of our systems. The stc > > is up and running, however we get below > > > > IKJ55365I A MESSAGE COULD NOT BE TRANSLATED TO ....+ > > > > IKJ55365I THE MVS MESSAGE SERVICE RETURN CODE WAS X'0000000C' AND THE > > REASON CODE WAS X'00000017'. > > > > > > Regards, > > Michael > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email to > [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
