On Thu, Sep 17, 2015 at 12:10 AM, Meenakshi, Vinoth - CW < [email protected]> wrote:
> Hi Ant, > > We couldn't able to access commands from master console or HMC, since the > system went onto wait-state. > > Central processor (CP) 0 is in a nonrestartable stopped state due to a > System Control Program (SCP) initiated reset of the I/O interface for > partition LPAR4. > The disabled wait program status word (PSW) is > 000200008000000000000000000040a2. > > Could you assist how we move forward from here. Thanks > Glad you have had your problem resolve (from later message in this thread). Hard Wait codes are in the "MVS System Codes" manual. The good information is the last 3 hex digits: 0A2 >From z/OS 1.12 (what we are running here): http://publibz.boulder.ibm.com/cgi-bin/bookmgr_OS390/BOOKS/IEA2H7B0/3.90 <quote> *Explanation:* Cross-system coupling facility (XCF) or cross-system extended services encountered a non-recoverable error and stopped the system. The system also issues this wait state in response to an operator request to stop the system. See z/OS MVS Diagnosis: Reference <http://publibz.boulder.ibm.com/cgi-bin/bookmgr_OS390/DOCNUM/GA22-7588/CCONTENTS?> for information on diagnosing sysplex problems. </quote> At my shop, I do the shutdowns and IPLs. I get the above every time after I do the z/OS operator command: V XCF,lpar,OFFLINE > > Regards, > Vinoth M > > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Anthony Thompson > Sent: Thursday, September 17, 2015 9:48 AM > To: [email protected] > Subject: Re: IPL Shutdown Problem > > ROUTE command not working is a completely separate issue. It won't happen > if that LPAR is outside of the sysplex. You'll need a console on that > system. Use the HMC if you need to, assuming you have one. > > Try the F OMVS, STOPPFS=FZS command on a SYS9 console. F > BPXOINIT,SHUTDOWN=FORKINIT should bring down both ZFS and OMVS. > > $PJES2,ABEND if you absolutely have to. > > Ant. > > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Meenakshi, Vinoth - CW > Sent: Thursday, 17 September 2015 1:23 PM > To: [email protected] > Subject: Re: IPL Shutdown Problem > > Thanks Ant & Lizette. > > F OMVS,STOPPFS=ZFS command worked and we were able to bring down ZFS for > one systemSYS3 and for other system SYS9 we are facing an issue. > > OMVS is down and we tried to issue STOPPFS=ZFS command and it's not > allowing. > > RESPONSE=SYS1 IEE618I ROUTE COMMAND REJECTED. SYS9 > > I think the system is out of sysplex now and still the below STC are > running in SYS9. > > ZFS STC03291 OMVS 15 EXECUTION SYS9 SYS9 > SYSLOG STC09890 +MASTER+ 15 EXECUTION SYS9 SYS9 > > Regards, > Vinoth M > > > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Anthony Thompson > Sent: Thursday, September 17, 2015 8:59 AM > To: [email protected] > Subject: Re: IPL Shutdown Problem > > Stop the ZFS address space. It should stop as part of OMVS shut down > anyway, but that's probably post-JES2 completion at your site. Issue > command F OMVS,STOPPFS=ZFS. SYSLOG should close as part of normal JES2 shut > down. Under z/OS 2.2, it is not recommended to run ZFS processing in its > own address space. > > Ant. > > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Lizette Koehler > Sent: Thursday, 17 September 2015 12:53 PM > To: [email protected] > Subject: Re: IPL Shutdown Problem > > The list is not the best place for an urgent issue. But we will try to > help. > > If this is PRODUCTION, Just take a Stand alone dump and IPL. > If this is any other system - how long can you be down before you IPL. > > Normally I do the SA Dump and IPL. I worry about why later. > > You do not want to spend a lot of time trying to resolve things when you > are IPL'ing. Especially if this is a critical system. > > You may need IBM's assistance in determine your shutdown issue, if you > have not used IPCS on a Stand alone dump. > > > Lizette > > > > -----Original Message----- > > From: IBM Mainframe Discussion List [mailto:[email protected]] > > On Behalf Of Meenakshi, Vinoth - CW > > Sent: Wednesday, September 16, 2015 8:03 PM > > To: [email protected] > > Subject: IPL Shutdown Problem > > > > Hi All, > > > > We are having issue with bringing down the JES2,two of the STC are > > running and it's not coming down. Even Purge command is not working. > > > > ZFS STC03291 OMVS 15 EXECUTION SYS9 SYS9 > > SYSLOG STC09890 +MASTER+ 15 EXECUTION SYS9 SYS9 > > > > Even we can't able issue command from other systems. > > > > RESPONSE=SYS9 IEE707I $DA,X NOT EXECUTED > > > > Kindly guide us on this. > > > > Thanks. > > Vinoth M > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email > to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email > to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email > to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email > to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > -- Schrodinger's backup: The condition of any backup is unknown until a restore is attempted. Yoda of Borg, we are. Futile, resistance is, yes. Assimilated, you will be. He's about as useful as a wax frying pan. 10 to the 12th power microphones = 1 Megaphone Maranatha! <>< John McKown ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
