Yes I did Both libs in the steplib are APF auth
One PROGXX one dynamic via setprog double checked the Dsn and vol as I know setprog doesn't do validity checking Thanks Sent from my iPhone > On Apr 28, 2014, at 9:38 AM, "Nims,Alva John (Al)" <[email protected]> wrote: > > Question: Is this being run under a TSO session? If so, did you logoff and > back on again after the SETPROG was done? > > Al Nims > Systems Admin/Programmer 3 > Information Technology > University of Florida > (352) 273-1298 > > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On > Behalf Of Micheal Butz > Sent: Monday, April 28, 2014 12:29 AM > To: [email protected] > Subject: Re: Autorization Code Question > > Prior to this I got an error running under TESTAUTH that the module was > loaded from an non-APF authorize data set > > Apparently this is the problem > > Sent from my iPhone > >> On Apr 28, 2014, at 12:23 AM, Jon Perryman <[email protected]> wrote: >> >> Yes as long as all datasets in steplib or joblib are APF authorized. >> >> Jon Perryman. >> >> >> ----- Original Message ----- >>> From: MichealButz <[email protected]> >>> >>> I have a module in APF authorized Library that is linkedit AC=1 when >>> I load this module shouldn't the high order byte of R1 be X'01' >> >> ---------------------------------------------------------------------- >> For IBM-MAIN subscribe / signoff / archive access instructions, send >> email to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email to > [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
